Removal and Replacement
Throttle Body Removal/Installation
CAUTION
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II), or while the ignition switch is in ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.
NOTE: If you are replacing or cleaning the throttle body, begin at step 1. If you are removing the throttle body temporarily, begin at step 4.
1. Connect the HDS while the engine is stopped.
2. Select the INSPECTION MENU with the HDS.
3. Do the TP POSITION CHECK in the ETCS TEST.
4. Turn the ignition switch to LOCK (0).
5. Disconnect the MAP sensor connector (A).
6. Remove the intake air duct (B).
7. Disconnect the throttle body connector (C).
8. Disconnect and plug the water bypass hoses (D), then remove the throttle body (E).
9. Install the parts in the reverse order of removal with a new gasket (F).
NOTE:
- After you torque the hose clamp screw (G), make sure the clearance (H) is less than 0.04 in (1.0 mm).
- After the installation, refill the radiator with engine coolant Service and Repair.
10. Do the PCM idle learn procedure PCM Idle Learn Procedure.