Rear Bumper: Service and Repair

Rear Bumper Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
- Push Push Pin Puller 07AAC-SJAA100
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Use the special tool to remove the clips.
- Have an assistant help you when removing and installing the rear bumper.
- Take care not to scratch the rear bumper or the body.
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the caps (A), then remove the bolts (B).





2. Remove the screws (C, D) and the clips (E) securing the rear bumper (F).

3. Pull out the rear bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacers (C).






4. With the help of an assistant, pull out the wheel arch portion away from the side spacer (A). Then pull out the rear bumper (B) to release the hooks (C) on the side bracket (D).






5. With the help of an assistant, pull out the rear bumper (A) to release the hooks (B) on both upper brackets (C).






6. If necessary, release the hooks, then remove the rear bumper absorber (A).






7. Install the bumper in the reverse order of removal, and note these items:

- Make sure the rear bumper engages the hooks (of both upper bracket, side bracket, and side spacers) on each side securely.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.