Front Seat Recline Motor Replacement
Front Seat Recline Motor Replacement
SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.
NOTE:
- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
1. Remove the front seat Front Seat Removal / Installation.
2. Remove the seat-back cover/pad Service and Repair.
3. Disconnect and detach the recline motor connector (A), and detach the harness clip (B).
4. Remove the push nut (A) from the motor side end of the connecting rod (B), then gently tap on the motor side of the connecting rod to remove it from the recline motor (C) and both recline adjusters (D).
The driver's seat is shown; the passenger's seat is similar.
5. Remove the rod cover (E).
6. Remove the bolt, then remove the recline motor (A). The driver's seat is shown; the passenger's seat is similar.
7. Install the motor in the reverse order of removal, and note these items:
- Replace the push nut with a new one. Make sure the push nut is installed correctly.
- Make sure the recline motor connector is plugged in properly, and push the harness clip into place securely.
- Apply medium strength liquid thread lock to the mounting bolt before reinstallation.