Brake Master Cylinder: Service and Repair

Brake Master Cylinder Replacement

NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

NOTE:

- Be careful not to damage or bend the brake lines during removal and inspection.
- After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.

1. Remove the left and right upper fender trim and left upper trim .

2. Remove the under-hood fuse/relay box, and move it aside Under-Hood Fuse/Relay Box Removal and Installation.

3. Remove the strut brace Service and Repair.

4. Remove the reservoir cap and brake fluid from the master cylinder reservoir with a syringe.

5. Disconnect the brake fluid level switch connector (A).





6. Disconnect the brake lines (B) from the master cylinder (C). To prevent spills, cover the line joints with rags or shop towels.

7. Remove the master cylinder mounting nuts (D).

8. Remove the master cylinder from the brake booster (E). Be careful not to bend or damage the brake lines when removing the master cylinder.

9. Remove the O-ring (F) from the master cylinder.

NOTE: Replace the O-ring whenever the master cylinder is removed.

10. Install the master cylinder with a new O-ring in the reverse order of removal, and note these items:

- Check the brake booster pushrod clearance Adjustments.
- Coat the O-ring with shin-etsu silicone grease.
- Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.
- Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary.

11. Bleed the brake system Service and Repair.

12. Spin the wheels to check for brake drag.