HFL Switch Test/Replacement

HFL Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Remove the driver's airbag Driver's Airbag Replacement.

2. Remove the switch case (A), then disconnect the 6P connector (B).





3. Remove the two screws and HFL switch (C).

4. Measure the resistance between the No. 2 and No. 5 terminals in each switch position according to the table.

HFL Switch





5. Use a diode tester between the terminals in each switch position according to the table.





6. If the resistance is not as specified, replace the switch.