A/T Idler Gear Shaft Reassembly

A/T Idler Gear Shaft Reassembly

1. Install the idler gear (A) over the idler gear shaft (B).






2. Place the idler gear (A) on press bases (B), and place a spacer (C) between the idler gear shaft (D) and a press to prevent damaging the idler gear shaft.





3. Install the idler gear using the press.

4. Install the 32.5 mm cotters (A), the cotter retainer (B), and the snap ring (C) on the idler gear shaft (D).





5. Install the 27.5 x 41 x 2.5 mm thrust needle bearing (E) and the 41.5 mm washer (F).

6. Check the idler gear shaft installation height A/T Idler Gear Shaft Installation Height Inspection/Adjustment.

7. Check the idler gear shaft installation height after the idler gear shaft is reassembled.