Front Driveshaft Installation

Front Driveshaft Installation

NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean.

1. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact area (A) of the outboard joint and front wheel bearing.

NOTE: The paste helps prevent noise and vibration.






2. Install a new set ring (A) into the set ring groove (B) of the left driveshaft inboard joint.






3. Install a new set ring (A) into the set ring groove (B) of the intermediate shaft.






4. Apply 0.5-1.0 g (0.018-0.035 oz) of super high temp urea grease (P/N 08798-9002) to the whole splined surface (A) of the right driveshaft. After applying grease, remove the grease from the splined grooves at intervals of 2-3 splines and from the set ring groove (B) so that air can bleed from the intermediate shaft.





5. Clean the areas where the driveshaft contacts the differential thoroughly with solvent and dry them with compressed air.

NOTE: Do not wash the rubber parts with solvent.

6. Insert the inboard end (A) of the driveshaft into the differential (B) or intermediate shaft (C) until the set ring (D) locks in the groove (E).

NOTE: Insert the driveshaft horizontally to prevent damaging the oil seal.






7. Install the outboard joint (A) into the front hub (B) on the knuckle.





8. Install exhaust pipe A Service and Repair.

9. Install the knuckle holder to the knuckle, and then tighten a new knuckle holder bolt (A) and a new nut (B).






10. Install the damper fork (A) over the driveshaft and onto the lower arm. Install the damper in the damper fork so the aligning tab (B) is aligned with the slot in the damper fork. Loosely install the damper pinch bolt (C).





11. Loosely install a new flange bolt (D) and a new damper fork mounting nut (E).

12. Connect the front stabilizer link (A) to the lower arm and loosely install a new flange nut (B) and the washer (C). Hold the stabilizer link ball joint pin (D) with a hex wrench (E), and tighten the new flange nut.





13. Place a floor jack under the lower arm, and raise the suspension to load it with the vehicle's weight.

NOTE: Do not put the floor jack under the ball joint.

14. Tighten the damper pinch bolt and the damper fork mounting nut while holding the flange bolt to the specified torque values, then remove the floor jack.

15. Apply a small amount of engine oil to the seating surface of a new spindle nut (A).





16. Install the spindle nut, then tighten it. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.

17. Clean the mating surfaces of the brake disc and the wheel, then install the front wheel.

18. Turn the front wheel by hand, and make sure there is no interference between the driveshaft and the surrounding parts.

19. Lower the vehicle.

20. Refill the transmission with recommended transmission fluid ATF Replacement.

21. Check the wheel alignment, and adjust it if necessary Service and Repair.

22. Test-drive the vehicle.