Transfer Assembly Installation (M/T)

Transfer Assembly Installation

1. Clean the areas where the transfer assembly contacts the transmission with solvent, and dry with compressed air.

2. Install the dowel pin (A) in the transmission, and install the transfer assembly (B) on the transmission.






3. Install the No. 1 propeller shaft (A) to the transfer companion flange (B) by aligning the reference mark (C) you made.






4. Secure the transfer breather hose bracket (A) on the transfer assembly with the bolt, and install the breather hose (B) over the breather pipe (C) with facing the dot mark (D) to the rear side of the vehicle.






5. Install exhaust pipe A Service and Repair.

6. Check the fluid level, and refill the transfer assembly with transfer fluid (hypoid gear oil), if necessary Transfer Assembly Fluid Inspection And Replacement (M/T).

7. Refill the transmission with MTF Service and Repair.

8. Test-drive the vehicle.