Trunk / Liftgate Latch: Service and Repair

Trunk Lid Latch Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the trunk lid.
- Take care not to kink the trunk lid opener cable.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the trunk lid trim panel.

2. Insert a trim tool through the latch cover (A) opening, and pry on the cover to release the latch tabs (B). Pull on the cover, and release the projection (C), then remove the cover.





3. Disconnect the trunk lid latch connector (D), and remove the bolts, then remove the trunk lid latch (E).

4. Note the position of the manual trunk lid opener cable end (A) in the trunk lid latch (B), then remove the cable from the latch.






5. Install the latch in the reverse order of removal, and note these items:

- Make sure the connector is plugged in properly and the cable is connected properly.
- Make sure the trunk lid opens properly and locks securely.
- Reinstall the manual trunk lid opener cable end (A) back to the position noted in step 4. Check the operation of the manual trunk lid opener, by pulling on the rubber tab inside the pass through opening. If necessary, adjust the cable end position.