Driver's Airbag Replacement

Driver's Airbag Replacement

NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the access panel (A) from the steering wheel, then disconnect the cable reel 4P connector (B) from the driver's airbag 4P connector.





3. Disconnect the horn switch 1P connector (C) from the driver's airbag 1P connector.

4. Remove the two TORX bolts (A) using a TORX T30 bit.





5. Remove the driver's airbag (B).

Installation

NOTE: If you are replacing a deployed driver's airbag, inspect the cable reel for heat damage. If there is any damage, replace the cable reel Service and Repair.

1. Place the driver's airbag (A) in the steering wheel, and tighten the new TORX bolts (B) to the specified torque, using a TORX T30 bit.

NOTE: Make sure the clearance (C) between the steering wheel and horn pad is the specified value.










2. Connect the driver's airbag 4P connector (A) and horn switch 1P connector (B), then install the access panel (C) on the steering wheel.





3. Do the battery terminal reconnection procedure.

4. Clear any DTCs with the HDS.

5. After installing the driver's airbag, confirm proper system operation:

- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.
- Make sure the horn works properly.