Steering Angle Sensor: Service and Repair

Steering Angle Sensor Replacement

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

1. Turn the ignition switch to LOCK (0).

2. With the front wheels in the straight-ahead position and the steering wheel centered, then remove the steering wheel Steering Wheel Removal.

3. Remove the steering column covers Steering Column Cover Removal/Installation and the cable reel.

4. Remove the combination switch assembly.

5. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).





6. Install the combination switch body assembly in the reverse order of removal, and note these items:

NOTE:

- Do not remove the steering angle sensor from the combination switch body assembly.
- When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up.
- Tighten the combination switch assembly/cable reel mounting screws in the proper sequence.