A/T Differential Carrier Bearing Replacement

A/T Differential Carrier Bearing Replacement

Special Tools Required

- Installer Attachment, 45 x 55 mm 07MAD-PR90100

NOTE:

- The carrier bearing and the bearing outer race should be replaced as a set.
- Inspect and adjust the carrier bearing preload whenever the carrier bearing is replaced.
- Check the carrier bearing for wear and rough rotation. If the carrier bearing is OK, removal is not necessary.

1. Remove the carrier bearing (A) with a commercially available bearing puller (B), a bearing separator (C), and a spacer (D).






2. Install the carrier bearings using the 45 x 55 mm installer attachment and a press.

NOTE:

- Press the carrier bearing on until it bottoms.
- Use the small end of the 45 x 55 mm installer attachment to install the carrier bearings.
- Press the carrier bearing on securely so there is no clearance between the carrier bearing and the differential carrier.