Manufacturer Code Charts: 60

Adaptive Cruise Control (ACC) DTC Troubleshooting: 60

DTC 60:

F-CAN A Communication error

1. Check the MIL on the gauge control module Initial Inspection and Diagnostic Overview.

Does the MIL stay on?

YES -

Go to the PGM-FI system's general troubleshooting information Initial Inspection and Diagnostic Overview.

NO -

Go to step 2.

2. Clear the DTCs with the HDS.

3. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.

4. Press the MAIN switch ON.

5. Check for DTCs with the HDS.

Is DTC 60 indicated?

YES -

Go to step 6.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections.

6. Press the engine start/stop button to select the OFF mode.

7. Disconnect the ACC unit 20P connector.

8. Measure the resistance between ACC unit 20P connector terminals No. 10 and No. 20. There should be less than 70 Ohms.





Is the resistance as specified?

YES -

Check for loose or poor connections. If OK, update the ACC unit Testing and Inspection, then recheck. If the ACC unit was already updated, replace the ACC unit Service and Repair.

NO -

Repair an open in the wire between the ACC unit and the branch of the F-CAN A line (F-CAN A H,F-CAN A L).