Operation CHARM: Car repair manuals for everyone.

Idle Speed: Testing and Inspection




Idle Speed Inspection

NOTE:

- Before checking the idle speed, check these items:
- The malfunction indicator lamp (MIL) has not been reported on, and there are no DTCs.
- Ignition timing
- Spark plugs
- Air cleaner
- PCV system

- Apply the parking brake and make sure the headlights are off.

1. Disconnect the evaporative emission (EVAP) canister purge valve connector.

2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.





3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

4. Make sure the HDS communicates with the PCM. If it doesn't, go to the DLC circuit troubleshooting Testing and Inspection.

5. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

6. Check the idle speed without load conditions: headlights, blower fan, radiator fan, and air conditioner off.





7. Let the engine idle for 1 minute with high electric load (A/C on, temperature set to max cool, blower fan on high, and headlights on high beam).





NOTE: If the idle speed is not within specification, do the PCM idle learn procedure PCM Idle Learn Procedure. If the idle speed is still not within specification, go to the symptom troubleshooting.

8. Reconnect the EVAP canister purge valve connector.