Operation CHARM: Car repair manuals for everyone.

Suspension Control Module: Service and Repair




Active Damper Control Unit Replacement

1. Press the engine start/stop button to select the OFF mode.

2. Remove the rear side trim panel.

3. Disconnect active damper control unit connector A (20P) and B (14P).





4. Remove the mounting nuts, and pull out the active damper control unit (C).

5. Install the active damper control unit in the reverse order of removal.

NOTE: Do not pinch the wire harnesses between the frame and the active damper control unit.

6. Do the memorizing rear suspension full rebound position Programming and Relearning.

7. Start the engine, then make sure there are no active damper system DTCs with the HDS.

8. Do the DAMPER FORCE OPERATION TEST in the FUNCTIONAL TESTS MENU with the HDS, then make sure all four damper units function normally.

9. Test-drive the vehicle, and check that the active damper system indicator does not come on.