Front Damper/Spring Removal/Installation
Front Damper/Spring Removal and Installation
NOTE: Except where called out, the illustrations show without active damper system.
Removal
1. Raise and support the vehicle Service and Repair.
2. Remove the front wheel.
3. With active damper system: Disconnect the damper coil 2P connector (A), and remove the flange bolt (B), and detach the harness clip (C).
NOTE: Be careful not to damage or contaminate the connector.
4. Remove the wheel speed sensor harness (A) and the brake hose (B) from the damper (C). Do not disconnect the wheel speed sensor connector.
5. Remove the flange nut (A), while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the damper.
6. Remove the damper pinch bolts (A) and flange nuts (B) from the damper.
NOTE: Do not allow the knuckle to rotate too far outward. This may allow the driveshaft inboard joint to come apart.
7. Remove the service caps (A).
8. Remove the flange nuts (B) from the top of the damper.
9. Remove the damper/spring (C).
NOTE:
- The left and right damper springs are different. Mark the springs L and R before you continue.
- Be careful not to damage the body.
Installation
1. Install the damper/spring (A) on to the frame. Note the direction of the damper mounting base (B) as shown.
NOTE: Be careful not to damage the body.
2. Loosely install the new flange nuts (C) to the top of the damper.
NOTE: Install the service caps (D) after tightening the flange nuts to the specified torque.
3. Loosely install new damper pinch bolts (A) and new flange nuts (B) to the damper (C).
4. Connect the stabilizer link (A) to the damper (B), and loosely install a new flange nut (C).
5. Tighten the flange nut to the specified torque, while holding the joint pin (D) with the hex wrench (E)
6. Tighten the flange nuts on top of the damper to the specified torque.
7. Tighten the damper pinch bolts while holding the flange nuts to the specified torque.
8. Install the service caps.
9. Install the wheel speed sensor harness (A) and the brake hose (B) to the damper (C).
10. With active damper system: Connect the damper 2P coil connector (A), and install the flange bolt (B), and attach the harness clip (C).
NOTE: Be careful not to damage or contaminate the connector.
11. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheel.
12. With active damper system: Start the engine, then make sure there are no active damper system DTCs with the HDS.
13. With active damper system: Do the DAMPER FORCE OPERATION TEST in the FUNCTIONAL TESTS MENU with the HDS, then make sure all four damper units function normally.
14. Check the wheel alignment, and adjust it if necessary Service and Repair.