Transmission Speed Sensor: Service and Repair

SPEEDOMETER VEHICLE SPEED SENSOR REPLACING
Removal
- Unplug connector from the Speedometer Vehicle Speed Sensor.
- Press down retaining bar, turn and pull out sensor.

Installation





- Replace both O-rings of sensor -arrow-.
- Coat sensor with special grease and install.
- Lock retaining bar properly in place.

TRANSMISSION INPUT SPEED SENSOR, REPLACING

NOTE: Do not use a sensor which has dropped onto the ground (permanent magnet breaks).

Removal
- Remove valve body.





- Remove Transmission Input Speed Sensor -1- at valve body.

Installation
- Use two spacer sleeves -2- (height: 20 mm) to install Transmission Input Speed Sensor -1-.

NOTE: The side of the sensor with the connector contacts faces toward the middle of the valve body.

- Change ATF or top up after repairs.

TRANSMISSION VEHICLE SPEED SENSOR, REPLACING

NOTE: Do not use a sensor which has dropped on the ground (permanent magnet breaks).

Removal
- Remove oil pan, as outlined above.





- Remove sensor -2-.

Installation
- Use two spacer sleeves -1- (height: 8 mm) to install sensor -2-.
- Change ATF or top up after repairs.