Connecting VAG 1551 Scan Tool
VAG 1551, Connecting And Selecting Function
NOTE: The VAG 1552 scan tool can be used instead of the VAG 1551, however no printout is possible.
Test requirements
- Battery Positive Voltage (B+) OK
- Supply voltage and fuses for respective system OK
- Ground (GND) connectors for transmission OK
- Check GND connections for corrosion and damage and repair if necessary.
- Check TCM GND connection per wiring diagram.
- Check battery GND strap and GND strap between battery and transmission.
- Selector lever in "P" position
- Parking brake applied
- Ignition switched off
- Connect VAG 1551 (VAG 1552) scan tool to 16-pin Data Link Connector (DLC) to left of steering column, using adapter cable VAG 1551/3.
NOTE:
- If nothing is shown on the display, check the power supply to the DLC.
- Additional operating instructions can be obtained by pressing the HELP button on the VAG 1551 scan tool.
- Press the -> button to advance through the program sequence.
Indicated on display 1)
V.A.G - ON BOARD DIAGNOSTIC HELP
1 - Rapid data transfer
2 - Blink code output
1) Operating modes 1 and 2 are displayed alternately
- Switch ignition on.
- Operate brake pedal one time.
- Press PRINT button to switch printer on (indicator light in button comes on).
- Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display
Rapid data transfer HELP
Insert address word XX
NOTE:
- After address word 33 is inserted and confirmed with the -Q- button, the OBD program can begin. OBD functions Selectable Functions (Modes) Under Address Word 33, CARB/OBD II
- After address word 00 is inserted and confirmed with the -Q- button, the automatic test sequence can begin (the DTC memory for every system is checked). Stored malfunctions are displayed in sequence and printed out.
Indicated on display 1)
V.A.G - ON BOARD DIAGNOSTIC HELP
1 - Rapid data transfer
2 - Blink code output
1) Operating modes 1 and 2 are displayed alternately
- Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display
Rapid data transfer HELP
Insert address word XX
- Press buttons -0- and -2- to insert "Transmission Electronics" address word 02.
Indicated on display
Rapid data transfer Q
02 transmission Electronics
- Press -Q- button to confirm input.
Indicated on display (control module identification)
8D0927156N AG5 01V 3,7l 2V US D74
Coding 00000 WSC 12345