Operation CHARM: Car repair manuals for everyone.

Procedures



Lock Carrier Service Position







NOTE:
- Do not remove noise insulation. Loosen only front quick-release screws
- Bumper removed

1 - Combination bolt
- 45 Nm (33 ft.lb)
2 - Combination bolt
- 45 Nm (33 ft.lb)
3 - Combination bolt
- 10 Nm (7 ft.lb)
4 - Combination bolt
- 10 Nm (7 ft.lb)
5 - Access hole for special tool
- For service position, attach special tool 3369 here
6 - Cowl attachment hole
- Attachment for service position







7 - Lock carrier
- For service position

- Screw special tool 3369 into threaded bore - 5 - on left side Fig. 1.
- Remove left and right mounting screws - 1 -.
- Remove mounting bolts - 3 - and - 4 - and pull lock carrier - 7 - forward.
- Secure lock carrier Fig. 2.
8 - Hood seal
9 - Hood lock cable
10 - Hole in side panel

NOTE: After assembly of the lock carrier, check headlight positioning and adjust if necessary.







Fig. 1 Screw in special tool 3369
- Screw special tool 3369 in at left and right as shown.
- Pull lock carrier forward until rear hole in lock carrier aligns with front threaded hole in fender flange.







Fig. 2 Secure lock carrier
- Secure lock carrier with screws at left and right as shown.