Power Trunk / Liftgate Lock Actuator: Service and Repair

Rear Lid Lock Actuator, Removing And Installing







- Remove tailgate trim.
- Disengage lock system at plug for vacuum line - 1 - and remove from lock actuator - 2 -.







- Press clamping pins (arrow) out and remove lock actuator - 1 - from lock - 2 -.
- Clamping pins must be snapped back into expanding clips during installation.
- Pry out using screwdriver if necessary.

NOTE: Illustration shows component after removal.







Fig. 1 Removing and installing tailgate trim
- Remove bolt - 1 - from handle well.
Torque: 1.5 Nm - 0.5 Nm (13 in.lb - 4 in.lb)
- Unclip lower rear hatch trim - 2 -.
- Unclip upper rear hatch trim - 3 -.

NOTE: When installing the lower trim, guide bars must be inserted in upper trim.







Fig. 2 Line routing
- Route pressure and vacuum lines through tie wraps - 4 - as shown in diagram and snap into clips - 3 -.
- Snap harness connector - 2 - into lock actuator.