Instrument Cluster

NOTES:
- The following table lists all possible Diagnostic Trouble Codes (DTCs) which the instrument cluster can recognize and which the VAG1551 scan tool can print.
- DTC numbers only appear on the printout.
- Before replacing any component shown as malfunctioning, check all related wiring and connections of these components and the Ground (GND) connections See "Electrical Wiring Diagrams Troubleshooting & Component Locations" .
- After the repair has been carried out and the functional system check, re-check and erase the DTC memory using the VAG1551 scan tool.
- The DTC memory records all static and sporadic (intermittent) malfunctions. A malfunction is considered static if it exists for at least 2 seconds (exceptions: 60 seconds for outside temperature display and 30 minutes, for engine coolant sensor). If the malfunction is not present after this time, it will be stored as a sporadic DTC and "/SP" will appear on the right side of the scan tool display.
- After switching the ignition on, all existing DTCs are set to sporadic. If they are still present after the system check, they will be stored as static DTCs.
- If a sporadic malfunction does not reoccur within 50 driving cycles (ignition on for at least 5 minutes and vehicle speed greater than 30 km/h or 18 mph), it will be erased.

DTC 00667, 00771, 00779:

DTC 01039, 01402, 65535: