Power Trunk / Liftgate Lock Actuator: Service and Repair

Rear Lid Lock Actuator, Removing And Installing

Removing







- Separate harness connector and detach vacuum line.
- Disengage operating rod - 4 - from clip - 3 -.
- Remove hex nuts - 6 - and remove lock actuator - 7 - from rear lid lock.







- Push out retaining pin - 3 - (2x) remove expanding clip.
- Push clip - 4 - back and disconnect.
- Remove lock actuator - 1 - from rear lid lock.

Installing
- Set lock cylinders in "open" position.







- Push ridged plate - 1 - to left. The first ridge of the plate - 1 - must snap into the first groove on the grooved segment - 2 -.