Basic Setting (Function 04)

Basic Setting (Function 04)

- Connect Scan Tool VAG1551 or 1552, enter address word 08 "A/C Heating Electronics" and move forward in program until "select function XX" appears in the display.
- Switch on printer by pressing the PRINT button (indicator lamp in the button comes on).
- Check DTC memory Check DTC Memory (Function 02) and repair all malfunctions which are displayed.
- Erase DTC memory. Erase DTC Memory (Function 05)
- Check coding and re-code if necessary.

Indicated on display (function selection)

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -4-.

Indicated on display

Rapid data transfer Q
04 - Basic Setting

- Press -Q- button to confirm input.

Indicated on display

Start basic setting HELP
Input display number XXX

- Press buttons -0- and -1-.
- Press -Q- button to confirm input.

NOTE:
The following flap motors are actuated in sequence and end positions are stored in A/C control head -E87-:
- Temperature Regulator Flap Motor -V68-
- Central Flap Motor -V70-
- Footwell/Defroster Flap Motor -V85-
- Air Flow Flap Motor -V71-
- End positions are determined from resistance values of potentiometers installed in the air/temperature flap flap motors.

Indicated on display

Basic setting 1
XXX XXX XXX XXX

Indicated on display

Basic setting 1
0 0 0 0

When all display fields indicate "0", basic setting is ended.

- Press -> button.

NOTE:
- For m.y. 1996, because A/C engine coolant temperature sensor G110 is not installed on USA/CDN models, during basic setting, DTC "00799 engine coolant temperature sensor G110" is stored and must be erased.
- For m.y. 1997 A/C engine coolant temperature (ECT) sensor -G110- is deleted, and will no longer load a DTC when checking DTC memory after ending basic setting.

- Check DTC memory. Check DTC Memory (Function 02)
- Erase DTC memory (function 05) and end output (function 06). Erase DTC Memory (Function 05)