Hot-Country Function, Activating/Deactivating

Hot-Country Function, Activating/ Deactivating

NOTE:
- Vehicles for hot countries are equipped with a coolant run-on pump which is actuated by the engine control module.
- In the case of non-hot country vehicles, the hot-country function must be deactivated after installation of a new control module, as otherwise a fault memory entry is made.

Procedure
- Connect vehicle diagnostic, testing and information system VAS5051 and select vehicle system "01 - Engine electronics" in selection. Ignition must be switched on. Connecting VAS 5051 Scan Tool

Display on VAS5051:







- Under -1- select diagnostic function "11 - Coding II".

Display on VAS5051:







1 - Enter code word

Deactivating hot-country function
- Enter "50000" for "deactivate hot-country function" in zone -2- and confirm by pressing -Q- button.

Activating hot-country function
- Enter "60000" for "activate hot-country function" in zone -2- and confirm by pressing -Q- button.
- Exit the function "11 - Login, or function 11 - Coding II" by pressing <- button.

Display on VAS5051:







- Under -1- select diagnostic function "08 - Read measured value block".

Display on VAS5051:







1 - Enter display group
- Press buttons -1-, -3-, and -2- for "display group number 132" in zone -2- and confirm entry by pressing -Q- button.

Display on VAS5051:







- Check indication in display field -4-.

Display Group 132:

- Exit function "08 - Read measured value block" by pressing <- button.
- Press "06 - Exit output".
- Switch ignition off.