Basic Setting (Function 04)
Basic Setting (Function 04)
NOTE: The air conditioning control changes with the 2001 to 2002 model year change. The climate control conversion on the Audi allroad does not occur with the 2001 to 2002 model year change, but instead changes in model year 2002.
- Connect VAG1551 Scan Tool (ST), Press buttons -0- and -8- to insert "AC/Heating Electronics" address word 08 and advance program until "Select function XX" appears on display, Scan Tool Connecting and Initial Checks
- Switch printer on via the PRINT button (indicator lamp in button lights up).
- Check DTC memory, and eliminate all displayed malfunctions.
- Erase DTC memory.
- Check coding, and correct if necessary. Testing and Inspection
Indicated on display (function selection):
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -4- to select "Basic Setting" function 04.
Indicated on display:
Rapid data transfer Q
04 - Basic Setting initiating
- Press -Q- button to confirm input.
Indicated on display:
Basic Setting HELP
Enter display group number XXX
- Enter display group number "01" or "001" (depending on scan tool software level).
- Press -Q- button to confirm input.
Basic setting procedure for vehicles from model year 2002
NOTE:
- The following positioning motors are now activated one after the other and their end positions are stored in the A/C Control Head - E87- (using resistance values of the potentiometers installed in the positioning motors)
-- Actuator for temperature flap left -V158-.
-- Actuator for temperature flap right -V159-
-- Central Air Flap Motor -V70-.
-- Defroster Flap Motor -V107-.
-- Recirculation Flap Motor -V113-
-- Air Flow Flap Motor -V71-.
Indicated on display:
Basic setting 1
XXX XXX XXX XXX XXX (XXX)
NOTE:
- The movement of the positioning motors can be followed on the display (by a change in feedback value).
- 3 actuator motors (2 actuator motors) are activated together.
Indicated on display:
Basic setting 1
0 0 0 0 0 (0)
When "0" appears on the display, basic setting has ended.
Continuation for all vehicles
- Press -> button.
Indicated on display (function selection):
Rapid data transfer HELP
Select function XX
- Press buttons 0- and -2- to select "Check DTC Memory", function 02.
Indicated on display:
Rapid data transfer Q
02 - Check DTC Memory
- Press -Q- button to confirm input.
Number of stored DTCs or "No DTC recognized" will be indicated on display.
X malfunctions recognized
Press -> button.
The stored malfunctions are displayed and printed out in sequence.
- When the last DTC has been displayed and printed out, the malfunction must be repaired using DTC table, Heating and Air Conditioning
- Press -> button.
Indicated on display (function selection):
Rapid data transfer HELP
Select function XX