Diagnostic Mode 1: Check Measured Values

Mode 1: Check measured values
In this diagnostic mode, all emissions-relevant measured values are displayed.

Test requirement:
- Coolant temperature at least 80 degrees C, see "PID 05: Coolant temperature".

Work procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- In diagnostic function "33 - OBD", select "Mode 1: Check measuring values".
- Select the desired measured value according to the PID (Parameter Identification), e.g. "PID 05 - Coolant temperature", via the following table.


NOTE:
- Specified values assigned to the measuring values are found in the corresponding component- and function tests.
- Measuring values of Engine Control Module (ECM) are displayed under "10 - Engine electronics" and measuring values of Transmission Control Module (TCM) are displayed under "1A - Transmission electronics".


PID1) Display measuring values
01: Monitoring status since erasing DTC memory
03: Condition of the fuel system
04: Calculated load condition value
05: Coolant temperature
06: Short time gasoline-air ratio bank 1
07: Gasoline-air ratio bank 1
12: Engine rotations per minute (RPM)
13: Vehicle speed
14: Valve timing adjustment at 1. cyl. to "advance"
15: Intake Air Temperature (IAT)
16: Air flow quantity at Mass Air Flow (MAF) sensor
17: Throttle valve position (absolute)
18: Availability status of secondary air
19: Available oxygen B1-S1, B1-S2
20: Sensor voltage Bank 1 - sensor 1
21: Sensor voltage Bank 1 - sensor 2
28: OBD-requirement for which this vehicle is designed -OBD II-CARB and OBD-EPA
52: Current output of oxygen sensor signal value Bank 1 -sensor 1
1) PIDs that are not relevant are not listed.

- End diagnosis and switch ignition off.