Diagnostic Mode 7: Components Continuously Monitored

Mode 7: Check Test Results Of Components That Are Continuously Monitored

This diagnostic mode indicates all stored DTCs of components and systems which are continuously monitored.

NOTE: In "Mode 3: Check DTC memory", no DTC entry is indicated.

Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.

NOTE: If the engine does not start up, crank engine using starter for at least 5 seconds, do not switch off ignition afterward under any circumstances.

- In diagnostic function "33 - OBD", select "Mode 7: Check test results of components that are continuously monitored".

The number of stored malfunctions or "0 malfunctions detected" is displayed.

- End diagnosis and switch ignition off.
- Repair stored malfunction(s) according to DTC table:
- SAE P0xxx-DTCs. P0010
- SAE P1xxx-DTCs. P1176
- SAE P2xxx-DTCs. P2096
- SAE P3xxx-DTCs. P3081

NOTE:
- The DTC tables are sorted by SAE code.
- In addition, "emission"-relevant malfunctions are indicated in the instrument cluster via the Malfunction Indicator Lamp (MIL) -K83-.
- Electronic Power Control (EPC) -relevant malfunctions are also indicated by the EPC Warning Lamp -K132- in the instrument cluster.

Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1 - Check DTC memory, "Mode 3: Check DTC memory". Diagnostic Mode 3: Check DTC Memory
2 - If necessary, erase DTC memory, "Mode 4: Reset/erase diagnostic data". Diagnostic Mode 4: Check Reset/Erase Diagnostic Data
3 - Generate readiness code. Readiness Code, Generating

- End diagnosis and switch ignition off.