Leak Detection Pump (LDP) -V144-, Checking

Leak Detection Pump (LDP) -V144-, Checking







Recommended special tools and equipment
- V.A.G 1526A multimeter
- V.A.G 1594A connector test kit
- V.A.G 1598/31 test box

Test requirements:
- Fuse for Leak Detection Pump (LDP) -V144- OK
- Fuel Pump (FP) Relay OK; checking. Fuel Pump (FP) Relay -J17- and Activation, Checking
- Ignition switched off.

NOTE: Voltage is supplied to Leak detection pump (LDP) -V144- via the Fuel Pump (FP) relay.

Procedure
- Remove left rear wheel.
- Remove rear left wheelhousing liner.







- Release and disconnect harness connector.

Checking internal resistance







- Connect multimeter for resistance measurement as follows.

Leak Detection Pump Specified value
(LDP) -V144- Terminal
1 + 3 640 to 720 ohm
2 + 3 15 to 17 Ohms

If specified values are not obtained:
- Replace Leak Detection Pump (LDP) -V144- item 9,

If specified values are obtained:

Checking voltage supply







- Connect multimeter for voltage measurement as follows:

Harness connector Measure to
Terminal
3 Engine Ground (GND)

- Operate starter briefly.
- Specified value: approx. battery voltage
- Switch ignition off.

If specified value is not obtained:
- Check wire connection from harness connector terminal 3 to Fuel Pump (FP) Relay -J17- via fuse for open circuit according to wiring diagram.
- Specified value: Wire resistance max 1.5 Ohms
- If necessary, repair wire connection.

If voltage supply is OK:

Checking wire connections
- Connect test box to wiring harness of Engine Control Module (ECM), ECM is not connected. Test Box, Connecting For Wiring and Component Test







- Check the following wire connections for open circuit according to wiring diagram.

Harness connector Test box Socket
Terminal
1 80
2 25

Specified value: Wire resistance max 1.5 Ohms

- Check wires for short circuit to each other as well as to B+ and Ground (GND).
- Specified value:Infinite Ohms (no continuity)
- If necessary, repair wire connection.

If no malfunctions are found in wires:
- Replace Engine Control Module (ECM).

Assembly is performed in reverse order of removal, note the following:
- Install rear left wheel housing.

Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1. Check DTC memory see "Mode 3: Check DTC memory". Mode 3: Check DTC Memory
2. If necessary, erase DTC memory see "Mode 4: Reset/erase diagnostic data". Mode 4: Reset/Erase Diagnostic Data
3. Generate readiness code. Readiness Code, Generating

- End diagnosis and switch ignition off.