Connect Diagnostic Tester
Connect Diagnostic Tester
Special Tools And Equipment
- Vehicle Diagnostic and Information System VAS 5052 with diagnostic wire VAS 5052/3
Test requirements:
- Fuses for engine electronics OK
- Ground (GND) connections at engine and transmission OK
- Battery voltage at least 12.7 V
- Parking brake engaged.
- Vehicles with automatic transmission: Selector lever in position "P" or "N".
- Electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.
Procedure
- Switch ignition off.
- Connect Vehicle Diagnostic and Information System VAS 5052 with diagnostic wire VAS 5052/3.
CAUTION: Observe safety precautions.
NOTE: If a malfunction message is displayed:
Depending on the desired mode, see "Selectable diagnostic modes" table : Select Diagnostic Mode
- Switch ignition on.
or
- Start engine.