Bearing Housing, Torsen Differential and End Cover, Removing and Installing

Bearing housing, Torsen differential and end cover, removing and installing, 01E, 6 Spd. M/T AWD





1 - Bearing housing
^ Disassembling and assembling

2 - Bolt, 25 Nm
^ 6 pieces

3 - Dished washer
^ Installation position: Large diameter (concave side) facing shims

4 - Washer
^ Qty. 2 or 3
^ Re-determining thickness





5 - Oil collector
^ Disassembling and assembling
^ Removing
^ Installing

6 - Multi-point socket head bolt, 150 Nm
^ Loosening
^ Tightening

7 - 2nd inner race for four-point bearing
^ Roller bearing side
^ Pulling off
^ Driving on

8 - Spring
9 - Torsen differential
^ Servicing only possible at manufacturer
^ Servicing mount for Torsen differential





10 - Bolt, 25 Nm
^ 5 pieces

11 - End cover
^ Servicing

12 - Gasket
^ Always replace

13 - Dowel sleeve
^ 2 pieces

14 - Manual transmission
^ Removing and installing 5th and 6th gear
^ Removing and installing input shaft, drive pinion, hollow shaft and shift mechanism in transmission

15 - Oil drain plug, 40 Nm





16 - Solenoid
^ 2 pieces
^ Clean

17 - Supporting plate
^ Installation position: Lug faces magnet

18 - Bolt, 25 Nm
^ 2 pieces