Diagnostic Mode 07: Check Test Results of Components That Are Continuously Monitored

Diagnostic Mode 07: Check Test Results Of Components That Are Continuously Monitored

Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.

NOTE: Depending on diagnostic tester and protocol used, diagnostic mode 07 and the information provided may be referred to by a different name.

Test requirements
- No DTCs stored in the DTC memory.
- Coolant temperature at least 80 degrees C.

Procedure
- Connect the diagnostic tester.
- Start the engine and run at idle.

NOTE: If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

- Select "Mode 7: Check test results of components that are continuously monitored" .

The number of stored DTCs or "0 malfunctions detected" will be displayed diagnostic tester screen.
- Switch the ignition off.

Refer to the following DTC tables for the diagnostic repair procedure:
- SAE P0xxxDTCs. P000A
- SAE P1xxx-DTCs. P1702
- SAE P2xxxDTCs. P2004
- SAE P3xxxDTCs. P3081
- SAE U0xxxDTCs. U0001

- Switch the ignition off.
- End of diagnosis.