Programming and Relearning

Adaptation, 01J CVT A/T FWD
Adaptation must be performed after the following operations:
^ After replacing the Transmission Control Module (TCM) -J217-
^ After coding the Transmission Control Module -J217-
^ After reprogramming (flash) the Transmission Control Module -J217-

Requirement:
^ No trouble codes in the DTC memory; read DTC memory.

Adaptation for driving forward
- Read Measured Value Block display group 010, engine at idle.





Display on VAS 5051
- Check whether transmission fluid temperature in display field 3 is higher than 60°C. A short test drive may be necessary to reach this temperature.
- Drive forward briefly and then brake to a stop again.
- Check display in display field 2.
^ Display must from change ADP. is running to "ADP. O.K."

If the display does not come up as described:
- Repeat start from stop and braking procedure until "ADP. O.K." is displayed.

If the specified value "ADP. O.K." is not obtained:
- Read DTC memory and correct malfunction. Adaptation must be performed again afterward.
- Perform adaptation for driving in reverse.

Adaptation for driving in reverse:
- Read Measured Value Block display group 011, engine at idle.





Display on VAS 5051
- Drive backward (in reverse) briefly and then brake to a stop again.
- Check display in display field 2.
^ Display must from change ADP. is running to "ADP. O.K."

If the display does not come up as described:
- Repeat start from stop and braking procedure until "ADP. O.K." is displayed.

If the specified value "ADP. O.K." is not obtained:
- Read DTC memory and correct malfunction. Adaptation must be performed again afterward.