Hood Seal Assembly Overview

Hood Seal Assembly Overview





1 Hood Seal

• Install seal on both sides on seals - 3 - at left and right.

• Press seal onto flange from rear toward front.

2 Plenum Chamber Seal

• Install seal on both sides on seals - 3 - at left and right.

CAUTION!
The must not be a gap between the ends of the seal.

• Press seal at both sides onto plenum chamber flange.

3 Right/Left Hood Seal

• Self-adhesive.

• Adhesion surface free of dust and grease.

• Remove protective paper before applying.

• Position release in passage - 5 -.

• Position seal on fender mounting bolt.

• Press seal firmly onto fender and suspension strut cap.

4 Hood

5 Hood Release

6 Bulkhead Insulation

• Make sure the bulkhead insulation is not touching the flange for the seal.

• The seal front section must lie over the insulation.

• After installing the seal, tighten the plastic nuts on the insulation.