Lock Carrier, Moving Into Service Position

Lock Carrier, Moving into Service Position

Special tools, testers and auxiliary items required

• Support Tool (3369)

Removing

- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen screws or quick-release fasteners - 1 - and - 2 - and remove front noise insulation.





- Remove quick-release fasteners - 3 - and remove rear noise insulation, if installed.

- Remove cover - 1 - in engine compartment (right side).





- Remove the bolts - arrows -.





- Disengage Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) - 1 - from air duct.

- Remove the air duct - 2 -.

- Remove cover - 1 - in engine compartment (left side).





- Remove hood seal from lock carrier and from fender bolted flanges.

- Remove front bumper cover. Refer to Front Bumper Cover / Fascia.

- Remove screws - arrows - at left and right.





- Unscrew bolts - arrows - at left and right impact absorbers.





- Thread Support Tool (3369) into empty bores at left and right.

- Carefully pull lock carrier toward front.