Coding II Login Procedure
Coding II Login Procedure
With engine stopped and ignition switched on, the following operations can be carried out with the function "11 - Login, or function 11 - Coding II:
=> [ Cruise Control System, Activating and Deactivating ]
=> [ Hot Climate Function, Activating and Deactivating ]
Cruise Control System, Activating and Deactivating
• Vehicles equipped with CCS, the CCS function must be activated after replacement of the engine control module.
• If the CCS function is activated in the engine control module of a vehicle without CCS, a DTC memory entry is made. If this is the case, the CCS function must be deactivated.
Procedure
- Connect vehicle diagnostic, testing and information system (VAS5051). Refer to => [ VAS 5051, Connecting and Select Functions ] VAS 5051, Connecting and Select Functions and select vehicle system "01 - Engine electronics" in selection. Ignition must be switched on.
Display on (VAS5051):
- Under - 1 - select diagnostic function "11 - Coding II".
All models
Display on (VAS5051):
1. Enter code word
Activate CCS
- Enter "11463" in zone - 2 - and confirm entry by pressing Q button.
Deactivate CCS
- Enter "16167" in zone - 2 - and confirm the entry by pressing Q button.
- Exit function "11 - Login, or function 11 - Coding II" by pressing arrow button.
Display on (VAS5051):
- Under - 1 - select diagnostic function "08 - Read measured value block".
Display on (VAS5051):
1. Enter display group
- Enter "066" for "display group number 066" in zone - 2 - and confirm entry by pressing Q button.
Display on (VAS5051):
- Check indication in display field - 2 -.
- Exit function "08 - Read measured value block" by pressing arrow button.
- Press "06 - End output".
- Switch ignition off.
Hot Climate Function, Activating and Deactivating
• Vehicles for hot countries are equipped with a coolant run-on pump which is actuated by the engine control module.
• In the case of non-hot country vehicles, the hot-country function must be deactivated after installation of a new control module, as otherwise a fault memory entry is made.
Procedure
- Connect vehicle diagnostic, testing and information system (VAS5051). Refer to => [ VAS 5051, Connecting and Select Functions ] VAS 5051, Connecting and Select Functions and select vehicle system "01 - Engine electronics" in selection. Ignition must be switched on.
Display on (VAS5051):
- Under - 1 - select diagnostic function "11 - Coding II".
Display on (VAS5051):
1. Enter code word
Deactivating hot-country function
- Enter "50000" for "deactivate hot-country function " in zone - 2 - and confirm by pressing Q button.
Activating hot-country function
- Enter "60000" for "activate hot-country function " in zone - 2 - and confirm by pressing Q button.
- Exit function "11 - Login, or function 11 - Coding II" by pressing arrow
Display on (VAS5051):
- Under - 1 - select diagnostic function "08 - Read measured value block".
Display on (VAS5051):
1. Enter display group
- Press buttons 1, 3, and 2 for " display group number 132" in zone 2 and confirm entry by pressing Q button.
Display on (VAS5051):
- Check indication in display field - 4 -.
- Exit function "08 - Read measured value block" by pressing arrow button.
- Press "06 - End output".
- Switch ignition off.