Air Injection Pump: Service and Repair

Secondary Air Injection Pump

Removing

- Remove cover - 1 - in engine compartment (right side).





- Remove the bolts - arrows -.





- Disengage Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) - 1 - from air duct.

- Remove the air duct - 2 -.

- Remove air filter housing - arrows -.





- Remove both bolts which are accessible from top on secondary Air Injection (AIR) pump bracket.

- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen screws or quick-release fasteners - 1 - and - 2 - and remove front noise insulation.





- Remove quick-release fasteners - 3 - and remove rear noise insulation, if installed.

- Disconnect the electrical connector - 3 -.





- Disconnect air hoses - 1 - and - 2 -.

- Remove screws accessible from bottom at secondary Air Injection (AIR) pump bracket.

- Remove Secondary Air Injection (AIR) pump with bracket.

- If necessary, disconnect Secondary Air Injection (AIR) pump from bracket.

Installing

Installation is performed in reverse order.

Tightening Specifications