Selector Lever Cable and Locking Cable Assembly Overview

Selector Lever Cable and Locking Cable Assembly Overview

• Lightly grease eyelet and ball socket with Polycarbamide Grease (G 052 142 A2) before installing.





1 Selector lever cable

• Do not bend or kink

• Removing and installing, refer to => [ Selector Lever Cable ] Selector Lever Cable

• Replace a damaged selector lever cable rubber boot.

• When installing, make sure rubber sleeve on transmission side is not twisted

• Adjusting, refer to => [ Selector Lever Cable, Checking and Adjusting ] 01V,01VA Transmission

2 Lock nuts, 12 Nm

3 Boot for selector lever cable

• Not available individually

• Replace a damaged selector lever cable rubber boot.

• To be buttoned into selector mechanism bottom cover

4 Retaining clip

5 Ignition/starter switch

• With ignition key removal lock

6 Locking cable

• For ignition key removal lock

• Do not bend

• Removing and installing, refer to => [ Locking Cable ] 01V,01VA Transmission

• Adjusting, refer to => [ Locking Cable, Adjusting ] Adjustments

7 Bolt, 9 Nm

8 Locking screw, 13 Nm

• For selector lever cable

• Loosen 1 turn for adjusting, do NOT remove completely

9 Selector lever cable screws

• To remove selector lever cable, move plastic retaining spring at selector mechanism forward slightly and put screws upward, only as far as necessary.

10 Selector lever cable securing clip

• Replace

11 Mounting bracket

• For selector lever cable on transmission

12 Bolt, 23 Nm

Heat Shield Over the Selector Lever Cable





1. Selector lever cable heat shield - A - to the transmission - 23 Nm

2. Bracket - B - to transmission - 23 Nm

3. Heat shield, exhaust system bracket and retaining bracket to transmission - 25 Nm.

4. Selector lever cable heat shield to transmission - 23 Nm.

5. Selector lever cable to bracket - 12 Nm