Lock Carrier, Moving Into Service Position

Lock carrier, moving into service position

Special tools, testers and auxiliary items required





^ Support tool 3369

Work procedure
- Remove both front wheels.





- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen quick-release fasteners - 1 - and - 2 - and remove front noise insulation.





- Remove front bumper cover.
- Remove air duct from in front of charge air cooler at left and right - arrows -.





- Remove air duct hose - 1 - to charge air cooler at lower left on lock carrier.

CAUTION: The air conditioning refrigerant circuit must not be opened.

- Unhook refrigerant line from bracket - 2 -.





- Remove bolts - arrows -.
- Remove air duct - 1 - and - 2 -.





- Remove electrical harness connectors - 1 - and - 2 - from bracket and free up electrical wiring.





- Remove hood seal from lock carrier and fender edges.
- Remove bolts - arrows - at left and right side of bumper.





- Thread support tool 3369 into empty bores at left and right.
- Remove bolts - arrows - at left and right impact absorbers.
- Carefully pull lock carrier toward front.

Installing
Installation is in reverse order of removal, note the following:

Note:
^ Hose connections and charge air system hoses must be free of oil and grease before installing. Do not use lubricant under any circumstances.
^ Secure all hose connections using hose clamps appropriate for the model type.

- Install lock carrier with attachments.





- Place torque support stop onto rubber buffer for torque support under its own weight and tighten the nuts - arrows -.
- Install front bumper cover.
- Check headlight adjustment.

Torque Specifications: