Selector Mechanism Cover, Selector Lever Handle Assembly Overview

Selector Mechanism Cover, Selector Lever Handle Assembly Overview

CAUTION!
Shift selector lever into position "P" and engage parking brake before working with the engine running.

• Grease mounting points and contact surfaces with Polycarbamide Grease (G 052 142 A2).





1 Selector lever

2 Selector lever shaft piece

• Removing and installing, refer to => [ Selector Lever Handle ] Selector Lever Handle

3 Selector lever handle

• Removing and installing, refer to => [ Selector Lever Handle ] Selector Lever Handle

4 Cover

• With selector scale and Tiptronic gate

• Removing and installing, refer to => [ Tiptronic Switch ] Tiptronic Switch and also unclipping symbol inserts

5 Symbol panel

• Clipped into the cover

6 Printed circuit board

• With integrated Tiptronic Switch (F189)

• Removing and installing, refer to => [ Tiptronic Switch ] Tiptronic Switch

• Switch consists of 3 Hall sensors, which are activated by a magnet on the transverse slide of the cover strip.

• If malfunctioning, start by checking whether solenoid is correctly fixed on cross slide masking panel => [ (Item 7) Cover strip ] , replace masking panel if necessary.

• Before replacing circuit board when DTC "18161" is entered in DTC memory, first check adjustment of selector lever cable, refer to => [ Selector Lever Cable, Checking and Adjusting ] 01V,01VA Transmission

7 Cover strip

• With solenoid for Tiptronic Switch (F189) on transverse slide

• Removing and installing, refer to => [ Tiptronic Switch ] Tiptronic Switch

8 Masking panel guide