Selector Lever Handle

Selector Lever Handle

Removing

- Shift selector lever into position "D".

- Turn sleeve - 1 - to left and push downward as far as stop.





- Carefully pull switch - 2 - just enough out of selector lever knob - 3 - until a cable tie can be inserted between button and selector lever.

• Do not remove button further under any circumstances, otherwise the selector lever knob will be damaged.

- Secure button in pulled-out position using cable tie - arrow - as shown in illustration.

- Remove selector lever knob upward.

Installing

Installation is reverse of removal, noting the following:

- Shift selector lever into position "D".

• To install new selector lever knob - 3 -, button 2 must be pulled out as far as stop and secured with a cable tie - arrow - or using assembly aid included with new knob.





• If the button was accidentally not secured, then it must not be pulled from selector lever knob using mechanical tools. Apply compressed air gun to bottom of knob and carefully press button out with compressed air.

- Position complete selector lever knob - 3 - on selector lever - button 2 faces driver. During this, the knob must engage into ring groove of the selector lever.

- Remove cable tie - arrow - or assembly aid, then button actuation engages in vertical groove of selector lever. If necessary press button into selector lever knob.

- Pull sleeve - 1 - upward and engage by turning clockwise.