Left Instrument Panel Fuse Holder
Left Instrument Panel Fuse Holder
Removing
- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
- Remove driver's storage compartment.
- Remove bolts - 1 - of fuse panel - 2 -.
- Release the tabs and remove the fuse panel from the instrument panel central tube.
- Cut cable tie - 1 -.
- Release cover for fuse panel - arrows -.
- Remove fuses on fuse panel.
- Pull off retaining strip for harness connectors - arrows - and remove harness connectors from fuse panel.
- Unclip socket - 1 -.
Installing
Install in reverse order of removal, observing the following:
• Attach all cable ties at the same locations when installing.
- Install driver's storage compartment.
- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.
Tightening Specifications