Basic Setting (Function 04)

Basic Setting (Function 04)

After replacing a headlight, axle sensor or the control module basic settings must be initiated. The following must be observed for this:

Test Requirement
- Vehicle must be loaded to an exactly definable weight
- Settle car (push down on car a few times so that shock absorbers and car bounce up and down).

Basic Setting, initiating
- Press buttons -0- and -4- to select "Basic Setting" function 04.

Indicated on display:

Rapid data transfer Q
04 - Basic Setting

- Press -Q- button to confirm input.

Indicated on display:

Basic Setting
Input display group number XXX

- Press buttons -0-, -0-, and -1- to input display group number 001.
- Press -Q- button to confirm input.

Indicated on display:

System in Basic Setting 1 ->
Please Wait

Headlights are moved into adjustment position (about 15 seconds).

Indicated on display:

System in Basic Setting 1 ->
Adjust headlights

Headlights are now in adjustment position.
- Adjust headlights using a headlight adjustment tool (e.g. VAS5046).

Basic setting 1 turns regulation off and "Headlights not adjusted" will be stored in DTC memory.
- Press -> button.

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -4- to select "Basic Setting" function 04.

Indicated on display:

Rapid data transfer Q
04 - Basic Setting

- Press -Q- button to confirm input.

Indicated on display:

- Press buttons -0-, -0-, and -2- to input display group number 002.
- Press -Q- button to confirm input.

Indicated on display:

System in Basic Setting 2 ->
Normal position learned

The control module has stored this position as the normal position. "Headlights not adjusted" is erased from DTC memory and regulation is switched back on.

- Press -> button.

Indicated on display:

Rapid data transfer HELP
Select function XX