Ignition Coil: Service and Repair

Ignition Coils with Power Output Stages

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing

- Remove engine cover. Refer to => [ Engine Cover with Air Filter Element ] Service and Repair.

- Remove both bolts - 1 - of the connector strip.





- Pull all ignition coils approximately 30 mm out of spark plug shaft using (T40039).





- Unlatch the electrical connections - arrows - and disconnect all the connections at the same time from the ignition coils.





- Using the (T40039) remove all ignition coils from the spark plug shaft.

Installing:

- Insert all ignition coils loosely into each spark plug shaft.

- Align the ignition coils to the connectors and then connect all of the connectors simultaneously onto the ignition coils.





- Press the ignition coils uniformly onto the spark plugs by hand (do not use an impact tool).