Lane Change Assistance

Lane Change Assistance

=> [ Lane Change Assistance Button ]

=> [ Lane Change Assistance Warning Lamps ]

=> [ Lane Change Assistance Control Modules ]

Lane Change Assistance Button





The lane change assistance button (E530) - arrow - sits in the switch strip and cannot be replaced separately if faulty.

- Replace the button in the instrument panel. Refer to => [ Instrument Panel Button ] Instrument Panel Lamps and Switches.

Lane Change Assistance Warning Lamps

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)

• Protective gloves

Removing






Risk of injury.

• Wear protective gloves.

• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.

- Press mirror glass - 1 - out of mirror adjusting unit - arrow - using (80 - 200).

- Disconnect the electrical connectors - 2 - and - 3 - for mirror heating on the rear side of the mirror glass.





- Unclip the electrical connector from the bracket - 5 -, if applicable.

- Disconnect the electrical connector - 4 -.

- Remove the screws - 4 - and - 5 -.





- Release the retaining tabs - 3 - in the - direction of arrow A -.

- Release the retaining clip - 1 - and remove the exterior rearview mirror housing - 2 - from the cover - B arrows -.

- Press the mirror adjusting unit down and pull the exterior rearview mirror housing - 1 - upward slightly.





- Disconnect the electrical connector - 2 - for the lane change assist warning lamp on the front side of the mirror adjusting unit mount - 3 -.

- Pull the exterior mirror housing upward and disconnect the electrical connector - 3 - for the LED - 2 - in the mirror.





• Ignore items - 1 and 4 - and the - arrow -.

- Release the retaining tabs - A arrows - and press the lane change assist warning lamp - 1 - out of the exterior rearview mirror housing - 2 - - arrow B -.





Installing

Install in reverse order of removal, observing the following:

• If LED is faulty, lane change assistance warning lamp in exterior mirror must be completely replaced.

- Install the exterior rearview mirror housing.

Lane Change Assistance Control Modules

Removing





- Remove rear bumper cover.

- Disconnect electrical connector - 3 -.

- Remove bolts - 2 - and - 4 -.

- Remove the lane change assist control module - 1 - from the mount on the bumper - arrow -.

Installing

Install in reverse order of removal, observing the following:

- Install the cover on the rear bumper.

Lane change assistance control module must be re-calibrated each time bumper cover is removed. Refer to => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing for Calibration.