Front Toe Constant S, Adjusting

Front Toe Constant S, Adjusting

- Loosen the nut - A -.





- Remove the bolt - B - approximately 4 mm.

- Push the tie rod joint downwards onto the stop.

Specified values for wheel alignment. Refer to => [ Wheel Alignment Specifications ] [1][2]Alignment.

- Install the bolt - B - until the specified value is reached exactly.





- Tighten the nut - A -. Refer to - item 9 - in => [ Power Steering Gear Assembly Overview ] Power Steering Gear Assembly Overview, and check the value.

- Tighten the bolt - B -. Refer to - item 7 - in => [ Power Steering Gear Assembly Overview ] Power Steering Gear Assembly Overview.

- Raise the vehicle slightly with the axle lift, the wheels must not loose contact with turn tables.

- Remove the securing pins from the cylinders and install the threaded spindles in the cylinder.

- Lower the vehicle onto the (VAG 1925/1) with the axle lift.

- Vehicle is in starting position.

Checking Toe Constant after Adjusting

Wheel alignment equipment will check toe constant again.

If the measured values for the second check are within the check value tolerances then the adjustment is OK.

If measured values are not within control values, they must be set again in raised position.