Left and Right Engine Mounts

Left and Right Engine Mounts

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Adapter (10 - 222 A /21)

• Engine Support Supplement Set (T40093)

Removing

• During installation, all cable ties must be installed at the same location.

- Remove rear engine cover - 2 - - arrows -.





- Remove cover above coolant reservoir - arrows -.





- Remove rubber seal - 1 - and remove plenum chamber covers - 2 - and - 3 -.





- Remove refrigerant line bracket at left from strut tower - arrow -.





- Remove clip - 1 - at right.





- Unclip fuel line and vacuum pump from bracket - 2 - on strut tower.

- Remove suspension strut cross member rear bolts - 3 -.





- Secure (10 - 222 A) to strut towers with (10 - 222 A /21).

• The adapters are marked for the left and right side of the vehicle.

• The center contact point - 2 - on the adapter is placed on the suspension strut cross member front bolts.

• The adapters are tightened with the rear bolts - 3 - for suspension strut cross member.

• The knurled thumb screw - 1 - must be turned downward far enough so that the contact plate rests on the strut tower.

- Secure the spindles of the (10 - 222 A) at the rear engine lifting eyes.





- Tension the engine with the spindles of the engine support bridge.

- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Open the quick-release fasteners - 1 - and - 2 - and remove noise insulation.





- Evenly remove left and right bolts - 2 - on stabilizer bar retaining clamps and rotate stabilizer bar - 1 - downward.





- Remove left and right bolts - 1. 2, 3 - and remove engine carrier.





Left engine mount:

- Disconnect the connector on the left electro-hydraulic engine mount solenoid valve (N144).

- Remove bolts - 1 to 3 - and remove engine support from engine mount.





Right engine mount:

- Disconnect the connector - arrow - on the right electro-hydraulic engine mount solenoid valve (N145).

- Remove bolts - 1 to 3 - and remove engine support from engine mount.





Continued for both sides:

- Remove bolt - arrow - and remove engine mount from engine support.





Installing

Installation is in reverse order of removal, note the following:

- Install subframe.

- Install stabilizer bar.

Tightening Specifications