Brake Light Switch: Service and Repair

Brake Lamp Switch

• Remove the brake light switch in order to adjust.

• To ensure a secure fit, the switch may only be installed once.

Removing

- Disconnect the electrical connector.

- Turn the brake light switch counterclockwise 45 degrees in order to remove.

Installing

Installation is in the reverse order of removal. Note the following:

- Pull out the brake light switch plunger as far as it will go - arrow -.





- Insert the switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.

- Install the driver side storage compartment.

• The brake pedal must not be actuated during installation.

• When installing the brake switch, the plunger adjusts itself automatically.

- Guide the switch through the installation hole, press against the pedal and secure by turning 45 degrees clockwise.





After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).