Front Door Window Motor: Service and Repair

Window Regulator Motor

Removing

- Remove door trim.

• Motor for window regulator can be removed or installed in every position of motor or side window.

- Disconnect electrical connectors.

- Remove bolts - 2 - and remove motor - 1 -.





Installing

- Ensure threaded pins - arrows - are engaged in door inner panel.

- Slide on window regulator motor - 1 - and secure with bolts - 2 -.

- Attach electrical connector.

• After installing motor, switch ignition on and off again with wires connected.

• Then move door window upward to stop and keep pressing switch for window regulator for approx. 2 seconds longer.

• This position is the base position and the high- and low-running function is activated.

Tightening torques => [ Window Regulator Assembly Overview ] Front Door Window Regulator Assembly Overview.