Locking Cable Adjusting

Locking Cable Adjusting

Special tools, testers and auxiliary items required

• Adjustment pin for shift lock (3352 A)

• Angle grinder

• Protective glasses

Work preparations

• The procedure described below will save you the effort of removing the center console.

- Cut through adjustment pin for shift lock 3 ( 3352 A) at rear end of flat area - arrow - using a cutting grinder.





CAUTION!
Wear protective glasses.

- Order a new Adjustment Pin for Shift Lock (3352 A) as a replacement for other applications.

Adjustment requirements

• Locking cable in the installation position

• Selector lever in position "P".

• Ignition key in removal position.

Procedure

• Tightening specifications. Refer to => [ Selector Lever Cable and Locking Cable Assembly Overview ] Selector Lever Cable and Locking Cable Assembly Overview

- Remove shift mechanism cover. Refer to => [ Selector Mechanism Cover ] Selector Mechanism Cover.

• The selector lever handle and covers can remain installed.

- Remove ashtray in center console.

- Loosen bolt - 1 -.





• Support bracket - 2 - of locking cable must be movable by hand

- Insert the reworked adjustment pin for shift lock 3 (3352 A) between pin on locking cable lever and locking cable eye.

- Pull locking cable all the way in direction of - arrow - then tighten screw.

• It must be possible to easily remove and insert adjusting gauge for locking cable (3352 A) in this position.

- Remove adjustment pin.

- Install ashtray into the center console.

- Check ignition key removal lock after every adjustment of the locking cable. Refer to => [ Selector Mechanism, Checking ] 09LA Transmission.

- Install selector mechanism cover. Refer to => [ Selector Mechanism Cover ] Selector Mechanism Cover.