Main Fuse Panel, Right A-Pillar

Main Fuse Panel, Right A-Pillar

Removing





- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove lower A-pillar trim.

- Fold back floor carpet.

- Remove protective cover over main fuse panel.

- Fold cover - 2 - to side.

- Remove nuts - 1 - and - 3 -.

- Remove nut - 4 - for battery cable.

- If necessary, detach fuse panel from bulkhead.

• Precise assignment of right A-pillar main fuse panel can be seen from appropriate wiring diagram.

Installing

Install in reverse order of removal, observing the following:

- Install lower A-pillar trim.

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.

Tightening Specifications